PT2262 Wireless Module...
The PT2262 (Tx) transmitter module is designed to be used in conjunction with the PT2272-M4...
This low power transceiver module is based on the Maxim MAX485 IC to allow serial communication over very long cable runs (up 4000 feet / 1200 meters). Serial data can be transmitted in both directions (half duplex) at a data rate up to 2.5Mbps. The modules operate from a standard 5V power...
This low power transceiver module is based on the Maxim MAX485 IC to allow serial communication over very long cable runs (up 4000 feet / 1200 meters). Serial data can be transmitted in both directions (half duplex) at a data rate up to 2.5Mbps. The modules operate from a standard 5V power supply and use 5V logic levels allowing them to be interfaced to the hardware serial ports of microcontrollers such as Arduino/PIC etc. Direction of communication can be controlled with just one digital pin (see diagram). It is also possible to connect multiple modules together for communication between 2 or more devices. For even greater distances two modules can be configured as a repeater.
Each module contains one driver and one receiver. Drivers are short-circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.
Data connections to the modules are provided by a standard 0.1" pitch header pins which can also be soldered into standard prototyping PCB and breadboards. Screw terminals provide convention connection to the actual data cable.
VCC........5V
A............Non-inverting Receiver Input and No-ninverting Driver Output.
B............Inverting Receiver Input and Inverting Driver Output
GND.......0V
R0..........Receiver Output (to Rx pin of microcontroller)
RE..........Receiver Output Enable (Low to enable)
DE..........Driver Output Enable (high to enable)
DI...........Driver Input (to Tx pin of microcontroller)
Datasheet available on our support forum here.
The PT2262 (Tx) transmitter module is designed to be used in conjunction with the PT2272-M4...
The TB387 high powered module (HCMODU0089) provides a means of transmitting serial data over...
The PT2272-M4 (Rx) receiver module is designed to be used in conjunction with the PT2262 (Tx)...
Infrared receiver module uses a 1838 infrared receiver. This is a universal type, with steel,...
Low cost, small, low profile 21 key infrared remote control (HCIRRC0001). The remote uses the...
This class 2 Bluetooth module (HC-05) comes programmed with firmware that allows it to pass...
The HC-11 433MHz Wireless Serial Port Module is based on the TI C1101 ultra low-power wireless...
This relay module is designed for the ESP-01s ESP8266 module. It features a 6 pin IDC socket...
This item is a wireless 4 channel remote controlled module with a battery operated transmitter...
This amazingly priced wireless module allows any microcontroller to connect to a 802.11b/g/n...
Low cost superheterodyne receiver designed to be used with transmitter HCMODU0088. The...