WeMos D1 Mini DHT Temp/Hum Shield
The DHT Shield is a digital temperature and humidity sensor utilising the DHT11 sensor. Temperature range is 0~60C (+/-2C) and the humidity range is 20-90%RH (+/-5%RH).
The DHT Shield is a digital temperature and humidity sensor utilising the DHT11 sensor. Temperature range is 0~60C (+/-2C) and the humidity range is 20-90%RH (+/-5%RH).
WeMos note: The temperature and humidity data read from the sensor is the result of the last measurement (the sensor will make a new measurement after data is read from the sensor). To get real-time data, you need to read twice. It is not recommended to repeatedly read from the sensor, reading interval should be more than 2 seconds to ensure accurate measurements.
Connection
D4 on the D1 mini should be connected to Data Out pin on the DHT module.
Features:
Temperature: 0~60°C (±2°C)
Humidity: 20-90%RH (±5%RH)
More information can be found on our support forum here
Specific References
12 other products in the category
Wemos Dual Base
The Wemos dual base (HCWEMO0015) is designed to allow a Wemos shield to be connected to a...
WeMos Header Pin Set
A set of 8 pin headers for WeMos boards and shields. This pack consist of 2 x long pin (10mm)...
WeMos D1 Mini WS8212 RGB...
The WeMos WS2812B RGB Shield is a digital full colour (16777216 colour) RGB LED light source....
- Currently Out of Stock
WeMos D1 Mini OLED Shield
The WeMos Mini D1 OLED shield is a tiny 0.66" 64 x 48 pixel OLED display. Using OLED display...
- Currently Out of Stock
WeMos V2 Relay Shield
This relay shield is designed to be used with the WeMos mini & mini Pro ESP8266 based...
WeMos SHT30 Temp & Humidity...
WeMos D1 mini Prototyping...
This prototyping shield is designed for use with the WeMos D1 mini and mini Pro development...
- Currently Out of Stock
Wemos Triple Base
The Wemos triple base (HCWEMO0016) is designed to allow a Wemos shield to be connected to a...