TinyCircuits Accelerometer TinyShield

HCTICI0006

New

This Tinyshield features the high performance and low power Bosch BMA250 3-axis accelerometer. The BMA250 allows measurement of accelerations in three perpendicular axes and thus senses tilt, motion, shock, and vibration in your projects. There is also an integrated temperature sensor built in...

More details

This product is currently out of stock.

£ 12.50

+ wishlist

This Tinyshield features the high performance and low power Bosch BMA250 3-axis accelerometer. The BMA250 allows measurement of accelerations in three perpendicular axes and thus senses tilt, motion, shock, and vibration in your projects. There is also an integrated temperature sensor built in.

Even though the BMA250 is designed to run at 1.8V – the Accelerometer TinyShield incorporates level shifters and a local power supply to ensure proper and safe operation over the entire TinyDuino operating voltage range up to 5V.

You can also use this shield without the TinyDuino – there are 0.1″ spaced holes for power, ground, and the two I2C signals along the side of the TinyShield to allow you to connect a different system.


Specification:

Model number: ASD2611
Ultra compact size and weight (smaller than a US Quarter!)
Square Version: 20mm x 20mm (.787 inches x .787 inches)
Max Height (from lower bottom TinyShield Connector to upper top TinyShield Connector): 5.11mm (0.201 inches)
Weight: TBD grams (TBD ounces)
Bosch BMA250 Accelerometer
3-axix (X, Y & Z)
Digital resolution: 10bit
Resolution: 3.9mg
Measurement ranges: +-2g, +-4g, +-8g, +-16g
Sensitivity: 2g: 256LSB/g, 4g: 128LSB/g, 8g: 64LSB/g, 16g: 16LSB/g
Zero-g offset (over lifetime): +-80mg
Bandwidths: 1000Hz… 8Hz
Low Power: 139uA @2kHz data rate
I2C Mode used
Arduino pins A4 and A5 are used by this shield
Built in level shifters and linear power supply to allow your TinyDuino to run up to 5.0V operation

Further Information available on our support forum here.

Viewed products