Recently Purchased

Active filters

  • 1Pk NIMH AccuUltra Battery...

    £4.16
    • 250mAh capacity
    • Size: 9v
    • NiMH rechargeable
    • 1000 charges (approx.)
    • Packaging: 1 pack blister card - RRP: £7.99
    In-Stock!
  • Atmel ATTiny85 in DIP package

    £1.24

    The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter, programmable watchdog timer with internal...

    In-Stock!
  • TM1638 7 Segment Display &...

    £3.33

    This 8 digit seven segment display module (HCMODU0095) uses a TM6138 controller allowing full control of the display using just 3 digital pins on a microcontoller. In addition to the seven segment display there are 8 individually controllable 3mm LEDs and a keypad with 8 push buttons arranged in a single row. These can also be controlled through the TM6138 IC and so require no extra digital pins.

    In-Stock!
  • Hobby Components Protoduino...

    £4.99

    Designed as a means to easily go from your Arduino and breadboard prototype to a more permanent design, the Protoduino is a development board consisting of an Arduino compatible ATMega328P with bootloader and a large prototyping area with a similar layout to a standard breadboard. The kit consists entirely of through-hole components, making it easy to construct...

    In-Stock!
  • Hobby Components 100mm x...

    £2.08

    Want to show off your prototype in style? Then start with our snazzy alternatives to the boring old prototyping board. Available in 6 different colours (black, white, red, yellow, green & blue) and in two different sizes (50x50mm & 100x50mm). Not only will they help show off your project, but we have also designed them to be in the style of a standard breadboard.

    Product available with different options
  • 3.2" resistive touch screen...

    £12.49

    This serial SPI touch screen has a resolution of 320 x 240 pixels and includes a restive touch interface. Specifically designed for the ResbarryPi is can be plugged straight on to the Pi's GPIO header with no additional soldering or wiring required. Included with this item is a stylus pen for use with the resistive touch screen.

    In-Stock!
  • DS3231 RTC module for...

    £2.08

    A very compact real time clock (RTC) module is based on the high accuracy DS3231 IC and includes a rechargeable batter backup. The (HCRASP0009) module also has a header with a pinout specifically designed so that it can be plugged directly into the IO header of your Raspberry Pi without any need for additional wires or soldering. The module makes use of the Raspberry Pi's I2C hardware interface.

    In-Stock!
  • Raspberry Pi 2 Case (Black,...

    £0.83

    These very simple but elegant looking cases will keep your Rapsberry Pi 2 safely protected from accidental damage and short circuits. Made from ABS plastic and available in 3 different colours (black, white, & clear diffused). The 3 part design makes construction very straightforward and the 4 fixing screw will beep your Raspberry Pi secured firmly in the case. A rear ventilation plate will...

    In-Stock!
  • Single Row 40-Pin 2.54mm...

    £0.33

    A colourful range of single row pin headers. Sold in strips of 40 pins and have a pitch of 2.54mm/0.1" (standard pitch). They are also designed to be snapped into smaller lengths...

    In-Stock!
  • KY-008 650nm 5V Laser Module

    £0.83

    This 100mW laser module emits a small intense focused beam of visible red light. The example provided below shows how the module can be used with an Arduino and photo resistor module (available here) to perform basic remote signaling.

    In-Stock!
  • 170 Point Mini Breadboard...

    £0.83

    A colourful rang prototyping breadboards have 170 tie points and are perfect when space is an issue, or when your project doesn't call for larger boards. They are approximately 35 x 47 x 8.5mm and are available in the following colours.

    In-Stock!
  • 140 piece Wire set in...

    £2.49

    This set comprises 140 22AWG jumper wires in assorted colours and lengths. Ideal for use with most common types of prototyping breadboards they will help you to quickly prototype your design...

    In-Stock!