Allows hands-free connection of test equipment to IC pins or other electronic components.

Our hugely popular low cost 8 channel analyser (HCTEST0006) is designed to work with the sigrok open-source signal analysis software suite giving this analyser a feature list normally found on analysers costing significantly more... 

Set of ten high quality test clips attached to a ten way female DuPont cable. Cable length approximately 28cm...

Set of ten high quality test clips attached to a ten way female DuPont cable. Cable length approximately 28cm...

4 digit 0.36" LED digital display with reverse polarity, a refresh rate of 500ms and an operating temperature of -10°c ~ 65 °C. This voltage meter is red. Green and blue meters are also available.

4 digit 0.36" LED digital display with reverse polarity, a refresh rate of 500ms and an operating temperature of -10°c ~ 65 °C. This voltage meter is Green. Red and blue meters are also available.

4 digit 0.36" LED digital display with reverse polarity, a refresh rate of 500ms and an operating temperature of -10°c ~ 65 °C. This voltage meter is Blue. Green and red meters are also available.

Insulated PCB mount 4mm Banana socket - side stackable 4mm Angled Socket.

Material: 
1. Insu...

Insulated PCB mount 4mm Banana socket - side stackable 4mm Angled Socket.

Material: ...

Our hugely popular low cost 8 channel analyser (HCTEST0006) is designed to work with he sigrok open-source signal analysis software suite giving this analyser a feature list normally found on analysers costing significantly more....

Our hugely popular low cost 8 channel analyser (HCTEST0006) is designed to work with the sigrok open-source signal analysis software suite giving this analyser a feature list normally found on analysers costing significantly more...

These test hook clips measure approximately 5x1.5cm. They use a miniature sprung claw system and are capable of grabbing very small points, such as the legs of ICs/LEDs/Resistors etc., they are available in various colours. Removing the clips cap will reveal a solder-able tab allowing the clip to be soldered on to the end of a test lead.