Kapton tapes are made from Kapton polyimide film with silicone adhesive. They are compatible with a wide temperature range as low as -269°C (-452°F) and as high as 260°C (500°F). An excellent addition to any 3D Printer's toolbox, this tape helps to keep your bed clean and gives excellent adhesion to prints. The tape is 20mm wide and the roll is 33 metres long, so it will last a while!

This PTFE Tube is suitable for 1.75mm filament. Due to it's hard texture, this tubing is hard to damage and ages well. The tubes inner diameter is 2mm, and the outer diameter is 4mm. There are several advantages to PTFE, including its high working temperature of 250C. PTFE is non-toxic and corrosion resistant...

Heat insulation cotton is used in 3D printers on the nozzle to maintain warmth. The insulation cotton is made from heat-resistant ceramic fiber. This is of benefit as it helps to maintain temperature, thus saving power and decreasing the time it takes for the nozzle to get back up to temperature when your printer has been sat idle.

PLA, Poly Lactic Acid is probably the best choice when you first start 3D printing. It is refined from corn and grain, and as a biodegradable material, it can be degraded which means it's 100% environmentally friendly. This hard material has excellent strength and stiffness.

PLA, Poly Lactic Acid is probably the best choice when you first start 3D printing. It is refined from corn and grain, and as a biodegradable material, it can be degraded which means it's 100% environmentally friendly. This hard material has excellent strength and stiffness.

PLA, Poly Lactic Acid is probably the best choice when you first start 3D printing. It is refined from corn and grain, and as a biodegradable material, it can be degraded which means it's 100% environmentally friendly. This hard material has excellent strength and stiffness.

PLA, Poly Lactic Acid is probably the best choice when you first start 3D printing. It is refined from corn and grain, and as a biodegradable material, it can be degraded which means it's 100% environmentally friendly. This hard material has excellent strength and stiffness.

PLA, Poly Lactic Acid is probably the best choice when you first start 3D printing. It is refined from corn and grain, and as a biodegradable material, it can be degraded which means it's 100% environmentally friendly. This hard material has excellent strength and stiffness.