These battery holders are suitable for cell battery types CR2025 and CR2032. The left pin is approximately 0.9 x 0.4mm and the right pin is approximately 0.9 x 0.6mm.

This battery holder (HCBATT0008) holds 2 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

This battery holder (HCBATT0007) holds 4 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

These battery clips (HCBATT0006) have a standard male 2.1mm DC connector at one end and a PP3 9V battery clip / buckle at the other. The wire measures approximately 7.5cm. The D.C connector has the positive at the tip making it suitable for most Arduino boards with a DC connector.

6x AA cell ABS plastic battery holder (HCBATT0006) allowing for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends allowing for easy solder to a PCB or terminal. It has two mounting holes for permanently fixing to a surface. Depending on battery type fitted this holder can provide approximately 6V DC for remotely powering your projects.

• 1300mAh capacity
• Size: AA
• NiMH rechargeable
• 1000 charges (approx.)
• Packaging: 4 pack blister card - RRP: £5.99

• 900mAh capacity
• Size: AAA
• NiMH rechargeable
• 1000 charges (approx.)
• Packaging: 4 pack blister card - RRP: £4.99

• 250mAh capacity
• Size: 9v
• NiMH rechargeable
• 1000 charges (approx.)
• Packaging: 1 pack blister card - RRP: £7.99

This enclosed 4 x AA battery box has a built-in on-off switch, colour-coded leads and a detachable lid which keeps the batteries secure.