Charging: Linear charge

Input interface: Mini USB

Charging current: 1A (Adjustable, requires resistor change)

Input voltage: DC 4.5V-5.5V...

These battery holders are suitable for cell battery types CR2025 and CR2032. The left pin is approximately 0.9 x 0.4mm and the right pin is approximately 0.9 x 0.6mm.

• Regulated AC/DC power supply unit
• Includes 6 interchangeable output plugs
• Includes USB female adaptor
• Maximum DC voltages: 3v 4.5v 5v 6v 6.5v and 7v
• Colour: black (BK)
• Packaging: clamshell
• RRP: £14.99

The solar cells are encased and protected by a durable outer poly frame.

This battery holder (HCBATT0008) holds 2 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

10cm Female BEC Connector.

High quality silicone coated wires.

This battery holder (HCBATT0007) holds 4 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

Low cost 5V 0.8W/ 160mA solar cell (HCPOWE0005). Encased and protected by a durable outer poly frame. Copper terminals/pads are provided on the reverse side to allow positive and negative wires to be soldered directly onto the cell. 

A USB type A to 2.1mm DC Jack cable. Perfect for powering any device with a standard DC jack socket directly from a 5V USB power source. The cable is approximately 1 meter in length.

1. PFM control DC/DC boost

2. Input 0.9-5v dc, output 5v dc

These battery clips (HCBATT0006) have a standard male 2.1mm DC connector at one end and a PP3 9V battery clip / buckle at the other. The wire measures approximately 7.5cm. The D.C connector has the positive at the tip making it suitable for most Arduino boards with a DC connector.

This is a Female 5.5 x 2.1mm Power sockets ideally suited to connecting to DC jacks that then adapts to two screw terminals. The sockets function by separating the central core and outer component of the jack and passing these through to screw terminals. The adapter is solidly constructed and housed in rubber to allow repeated use.