Programmers / Interface

 

 

Active filters

  • USBTinyISP in circuit AVR...

    £7.49

    This USBTinyISP programmer is ideally suited for in circuit programming of AVR devices or for reflashing bootloaders onto Arduino based products. It includes a 6 and 10 pin SPI interface and cables. The 6 pin interface...

    Out-of-Stock
  • PIC K150 ICSP Programmer

    £8.33

    Product Description
    K150 is a low-cost high-performance PIC programmer, supporting the most popular PIC chips. Allows reading, writing, encryption, and uses high-speed USB communication for fast programming ( speed average PICSTART + 3-5 times ). Fully automatic programming checksum ; equipped with 40pin DIP programming ZIF socket, di...

    Last items in stock
  • STM8 & STM32 emulator and...

    £6.24

    A USB programmer and emulator for ST's range of STM8 and STM32 microcontrollers (HCDVBD0016). The programmer will work with any software that is compatible with the ST-Link V2 programmer including ST's own tool set (IAR, STVD etc). This programmer is also ideal for use with our own ranger of STM8 development/breakout boards.

    Last items in stock
  • USB to RS232 TTL Serial...

    £2.49

    USB to RS232 TTL PL2303HX auto converter module adapter with a 5V output, which provides the most convenient way to connect your RS232 TTL devices to your computer via the USB port. The cable has a built-in TTL COM PC-PL2303HX Chip and uses a standard USB type A male and TTL 4 pin connector. The cable length is approximately 100cm in length.

    In-Stock!
  • FTDI USB Serial Port Adapter

    £4.99

    - FT232RL chip
    - Both 5V/3.3V supply outputs
    - Supports 300bps~3Mbps between each standard baud rate
    - Supports Windows 10/8/7/CE/Vista/XP/2000/98/MacOS X
    - Comes with connection cable (18.4cm length)

    In Stock
  • STM8S105K4 Development Board

    £3.74

    This development/breakout board (HCDVBD0032) is based around the ST Microelectronics STM8S105K4 microcontroller. STM8 microcontrollers are an ultra low cost solution to embedded control. This development board provides convenient access to the devices I/O pins via standard 2.54mm pitch headers. Besides providing access to most of the microcontrollers I/O, there is additionally a...

    Last items in stock
  • PCF8574 I2C to 8-bit...

    £2.91

    This module (HCMODU0120) is a breakout board for the PCF8574 8-bit input/output (I/O) expander IC. Using this module you can expand the available digital I/O pins of your microcontroller via its serial I2C interface. The device features an 8-bit quasi-bidirectional I/O port (P0–P7), including latched outputs with high current drive capability for directly driving...

    Last items in stock
  • Silicon Labs CP2102 3.3V...

    £2.49

    A high performance USB to UART interface allowing you to communicate with serial devices such as microcontroller UART's using your PC. The module has a silicon labs CP2102 based device and a convenient pin header which includes a 5V and 3.3V supply. Tx and Rx data pins are at 3.3V TTL levels. Virtual COM port drivers are available for Windows, Mac, Linux, and Android operating systems.

    In Stock
  • STM8S103F3 P6 Development...

    £1.66

    This development/breakout board (HCDVBD0034) is based around the ST Microelectronics S103F3P6 microcontroller. STM8 microcontrollers are an ultra low cost solution to embedded control. This development board provides convenient access to the devices I/O pins via standard 2.54mm pitch headers (require soldering). Besides providing access to most of the microcontrollers I/O, there is additionally...

    Last items in stock
  • CH340 USB to TTL Serial...

    £2.49

    The CH340 USB to serial adaptor (HCMODU0076) makes use of the CH340 USB to serial IC to provide a low cost alternative to our popular FTDI based module. Although much cheaper this module doesn't lack in features or usability.

    In-Stock!
  • USBASP AVR programmer +...

    £2.91

    A compact USB in-circuit programmer (HCDVBD0031) specifically designed to program most versions of Atmel AVR microcontrollers. The programmer plugs straight into a USB port on your computer and features the standard Atmel 10 pin ICSP IDC header. With the included IDC cable this allows it to connect directly to many types of Atmel development boards. We have also included a...

    Out-of-Stock