6x AA cell ABS plastic battery holder (HCBATT0006) allowing for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends allowing for easy solder to a PCB or terminal. It has two mounting holes for permanently fixing to a surface. Depending on battery type fitted this holder can provide approximately 6V DC for remotely powering your projects.

This kit comprises one each of the following values:

7905  7906  7908 7909 7912 7915 7924

This kit comprises one each of the following values:

7805 7806 7808 7809 7810 7812 7815 7818 7824

Charging: Linear charge

Input interface: Mini USB

Charging current: 1A (Adjustable, requires resistor change)

Input voltage: DC 4.5V-5.5V...

This enclosed 4 x AA battery box has a built-in on-off switch, colour-coded leads and a detachable lid which keeps the batteries secure.

The L78xx series of three-terminal positive regulators is available in TO-220, TO-220FP, TO-3, D²PAK and DPAK packages and several fixed output voltages, making it useful in a wide range of applications.

Versatile and accurate fixed voltage regulators suitable for currents up to 100mA with internal thermal overload protection and short-circuit current limit. Output voltage tolerance is +/-5%

These battery clips (HCBATT0006) have a standard male 2.1mm DC connector at one end and a PP3 9V battery clip / buckle at the other. The wire measures approximately 7.5cm. The D.C connector has the positive at the tip making it suitable for most Arduino boards with a DC connector.

These battery holders are suitable for cell battery types CR2025 and CR2032. The left pin is approximately 0.9 x 0.4mm and the right pin is approximately 0.9 x 0.6mm.

This battery holder (HCBATT0007) holds 4 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

This battery holder (HCBATT0008) holds 2 standard AAA batteries and its open design allows for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends to make soldering as easy as possible. It has two mounting holes for permanently fixing it to a surface.

Low cost 5V 0.8W/ 160mA solar cell (HCPOWE0005). Encased and protected by a durable outer poly frame. Copper terminals/pads are provided on the reverse side to allow positive and negative wires to be soldered directly onto the cell.