6x AA cell ABS plastic battery holder (HCBATT0006) allowing for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends allowing for easy solder to a PCB or terminal. It has two mounting holes for permanently fixing to a surface. Depending on battery type fitted this holder can provide approximately 6V DC for remotely powering your projects.
6x AA cell ABS plastic battery holder (HCBATT0006) allowing for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends allowing for easy solder to a PCB or terminal. It has two mounting holes for permanently fixing to a surface. Depending on battery type fitted this holder can provide approximately 6V DC for remotely powering your projects.
Specification:
Dimention: 5.7cm x 9.3cm x 1.5cm
Cell type: 6x AA
The L78xx series of three-terminal positive regulators is available in TO-220, TO-220FP, TO-3,...
This kit comprises one each of the following values:
7905 7906 7908 7909 7912 7915...
This bundle of regulators contains a total of 70, 10 each of the following values:
...
Charging: Linear charge
Input interface: Mini USB
Charging current: 1A...
Versatile and accurate fixed voltage regulators suitable for currents up to 100mA with...
These battery holders are suitable for cell battery types CR2025 and CR2032. The left pin is...
This kit comprises one each of the following values:
7805 7806 7808 7809 7810 7812 7815...
This battery holder (HCBATT0008) holds 2 standard AAA batteries and its open design allows for...
Low cost 5V 0.8W/ 160mA solar cell (HCPOWE0005). Encased and protected by a durable outer poly...
These battery clips (HCBATT0006) have a standard male 2.1mm DC connector at one end and a PP3...
This battery holder (HCBATT0007) holds 4 standard AAA batteries and its open design allows for...
This enclosed 4 x AA battery box has a built-in on-off switch, colour-coded leads and a...
Get ice cold in minutes or heat to boiling by simply reversing device. Used for numerous...
6x AA cell ABS plastic battery holder (HCBATT0006) allowing for easy insertion and removal of batteries. The holder has colour coded wires with tinned ends allowing for easy solder to a PCB or terminal. It has two mounting holes for permanently fixing to a surface. Depending on battery type fitted this holder can provide approximately 6V DC for remotely powering your projects.
