Wemos/Lolin D32 ESP32 development board

The Lolin D32 development board is based on the Espressif systems ESP32 low power system on a chip microcontroller. It has many powerful features including a dual core Arm based processor, Wi-Fi, Bluetooth, I2C, I2S, SPI, ADC, DAC, and 4MB flash. The D32 module provides these features in a convenient DIP format and can be programmed directly from a USB interface - no additional programming hardware is required. Additionally, the module also includes a charging circuit for a single cell 3.7V lithium battery, meaning that this module can easily be used in remote applications.

For Arduino users compatibility can be added to the Arduino IDE via the board manager feature - see our support forum for more information. Please note that some features may not currently be supported by the Arduino IDE, however, board files are frequently updated.


Features: 

Espressif official ESP32-WROOM-32 module
Latest ESP32 Version: REV1
4MB FLASH
Lithium battery interface, 500mA Max charging current
Compatible with Arduino, MicroPython
Default firmware: latest MicroPython
CPU: Xtensa dual-core (or single-core) 32-bit LX6 microprocessor, operating at 160 or 240 MHz and performing at up to 600 DMIPS
520 KiB SRAM
Wi-Fi: 802.11 b/g/n
Bluetooth: v4.2 BR/EDR and BLE
12-bit SAR ADC up to 18 channels
2 × 8-bit DACs
10 × touch sensors (capacitive sensing GPIOs)
Temperature sensor
SPI
I²S interfaces
I²C interfaces
UART
SD/SDIO/CE-ATA/MMC/eMMC host controller
SDIO/SPI slave controller
CAN bus 2.0
Infrared remote controller
Motor PWM
LED PWM
Hall effect sensor
Ultra low power analog pre-amplifier

Drivers and instructions are available on our support forum here.