RM95 Breakout Board

£1.99
VAT included

This is a breakout board for the RM95 wireless LoRa module (HCMODU0247). The purpose of this board is to bring out the 2mm pitch pads of the RM95 module to a more convenient and breadboard/Dupont friendly 0.1” pitch. Additionally, the breakout board brings out the antenna pin to a separate pad suitable for soldering a wire/coil/or SMA antenna.

Kit Options
  • Without Antenna
  • With Antenna
Quantity

This is a breakout board for the RM95 wireless LoRa module (HCMODU0247). The purpose of this board is to bring out the 2mm pitch pads of the RM95 module to a more convenient and breadboard/Dupont friendly 0.1” pitch. Additionally, the breakout board brings out the antenna pin to a separate pad suitable for soldering a wire/coil/or SMA antenna.

 

Supplied with the kit are 2x 0.1” pitch header pins for optionally soldering to the upper or lower sides of the PCB and a 900MHz coil antenna (if the HCPROT0104B version of the kit is purchased).


Please note: This kit requires soldering of the RM95 module to the breakout board. Please see the guide below for recommended soldering steps.

 

The RM95 module is NOT included with this kit. The module can be purchased separately here.

 

Specification:
Product code: HCPROT0104 (no antenna) / HCPROT0104B (coil antenna)
Module type: RM95 868Mhz or 915MHz
Module dimensions (ex antenna): 33mm x 24mm

 

See our support forum for a soldering guide.

HCPROT0104
90 Items

Specific References

You might also like

1 other product in the category