BF350-3AA Strain Gauge Module
This strain gauge module uses a BF350 sensor to measure mechanical stresses in solid...
- Currently Out of Stock
The MAX471 module (HCSENS0041) is a complete, bidirectional, highside current-sense amplifier for portable PCs, telephones, and other systems where battery/DC power-line monitoring is critical. High-side power-line monitoring is especially useful in battery-powered systems, since...
The MAX471 module (HCSENS0041) is a complete, bidirectional, highside current-sense amplifier for portable PCs, telephones, and other systems where battery/DC power-line monitoring is critical. High-side power-line monitoring is especially useful in battery-powered systems, since it does not interfere with the ground paths of the battery chargers or monitors often found in “smart” batteries. The MAX471 has an internal 35mΩ current-sense resistor and measures battery currents up to ±3A. The module has a built-in 2K Ohm sens resitor giving the module a full sensor range of +/- 3A. An open-collector SIGN output indicates current-flow direction, so the user can monitor whether a battery is being charged or discharged. Operation is from 3V to 36V, and draws less than 100µA over temperature
The module is also supplied with optional 2 way screw terminal and 0.1" pitch header (requires soldering).
Specification:
Product code: HCSENS0041
Current sens max: +/- 3A
Current sens voltage: 3 to 36V
Sensor output: 1V / Amp
Dimensions: 20mm x 19.5mm
Pinout
Sensor
RS+.........Load positive supply (3 to 36V)
RS-..........Connect to load or charger
Interface:
RS+.........Alternative load positive supply (3 to 36V)
GND.........Connect to loads 0V/GND supply
OUT..........Current sensor output (1V / Amp, 3V max)
SIGN........Current flow direction. An open-collector logic output (low = current flow from RS+ to RS-).
GND.........Alternative GND (Connect to loads 0V/GND supply)
RS-...........Alternative load/charger connection.
This strain gauge module uses a BF350 sensor to measure mechanical stresses in solid...
This water level sensor / float switch can be used to sense when a liquid has reached a set...
This temperature sensor and module makes use of the Maxim MAX6675 K-Thermocouple to digital...
A linear sliding potentiometer module allowing for very smooth and precise control. The module...
- Photosensitive diode
- Working power: + 5V
- Working current: < 10mA
-...
The perfect accompaniment to our Pyroelectric Infrared PIR Motion Sensor Detector Module...
- Main chip: LM393
- Working voltage: DC 5V
- Single channel signal output
-...
The BMP180 is the function compatible successor of the BMP085, a new generation of high...
The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
This 5mW laser module emits a small intense focused beam of visible red light. The example...
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND)...
The DHT21 digital temperature sensor is one of the commonest from the range of DHT temperature...
The TMP102 device is a digital temperature sensor ideal for NTC/PTC thermistor replacement...
This is a very simple module that contains a magnetic reed switch which will close its...