Hobby Components Ultimate...
Our Ultimate Sensor Kit has been revamped, and, unlike most in the market, is mercury free! It...
- Currently Out of Stock
The BMP180 is the function compatible successor of the BMP085, a new generation of high precision digital pressure sensors for consumer applications. The ultra-low power, low voltage electronics of the BMP180 is optimized for use in mobile phones, PDAs, GPS navigation devices and outdoor equipment.
The BMP180 is the function compatible successor of the BMP085, a new generation of high precision digital pressure sensors for consumer applications. The ultra-low power, low voltage electronics of the BMP180 is optimized for use in mobile phones, PDAs, GPS navigation devices and outdoor equipment. With a low altitude noise of merely 0.25m at fast conversion time, the BMP180 offers superior performance. The I2C interface allows for easy system integration with a microcontroller. The BMP180 is based on piezo-resistive technology for EMC robustness, high accuracy and linearity as well as long term stability.
The module (HCMODU0101) measures a tiny 13mm x 10mm and contains the 3.3V regulator allowing the module to be safely powered from a 5V source. Solder terminal for power and I2C interface are provided with 10K pullups for the I2C data and clock pins.
Product code: HCMODU0101
Power supply: 5V
Interface: I2C
Pressure accuracy (hPa): -4.0 to +2.0
Pressure resolution (hPa): 0.01
Temperature resolution (oC): 0.1
Module dimensions: 13mm x 10mm
Raspberry Pi users:
For Raspberry Pi uses we have tested this module with the free Cayenne cloud based IoT software platform. Simply connect the module to your Raspberry Pi as shown below and use the Cayenne software platform to get remote temperature and pressure readings without writing a single line of code.
You can create a free account simply by clicking our referral link below:
Arduino users:
To make using this module with your Arduino as easy as possible we have written an exclusive library (HCBMP180). This library can be downloaded from the software section of our support forum here:
viewtopic.php?f=58&t=2019
The library will allow you to obtain calibrated temperature and pressure measurements from the module. Additionally it can also be used to get absolute altitude, relative altitude, and pressure at sea level measurements.
Example Arduino sketch, excluive library and datasheet available on our support forum here.
Our Ultimate Sensor Kit has been revamped, and, unlike most in the market, is mercury free! It...
This water level sensor / float switch can be used to sense when a liquid has reached a set...
A side mounted waterproof float switch (HCSENS0015) which uses a magnet embedded in the float,...
This water sensor is designed for water detection and can be widely used in sensing rainfall...
Working voltage: 5V
Circle of Pulses: 20
Product Code: HCMODU0063
Diagrams,...
This 5mW laser module emits a small intense focused beam of visible red light. The example...
The Aosong AM2315 is a wall mountable temperature and humidity sensor (HCSENS0043) based on...
- Main chip: LM393
- Working voltage: DC 5V
- Single channel signal output
-...
This module (HCMODU0098) is a breakout board for the Texas Instruments ADS1115 ADC. This...
A linear sliding potentiometer module allowing for very smooth and precise control. The module...
This bundle consists of two speed encoder photoelectric pulse output modules. The HC-020K...