microSD card reader module of RAMPS shield
A microSD card reader module with built in 3.3V level shifter which allows safe interfacing to any microSD cards that support an SPI interface. This module has primarily been designed to work with our RAMPS compatible 3D printer shield (See HC3DPR0002 in our shop). The module will directly interface with the AUX-3 connector on the RAMPS shield.
A microSD card reader module with built in 3.3V level shifter which allows safe interfacing to any microSD cards that support an SPI interface. This module has primarily been designed to work with our RAMPS compatible 3D printer shield (See HC3DPR0002 in our shop). The module will directly interface with the AUX-3 connector on the RAMPS shield.
Although designed for this purpose in mind, this module will work fine with any microcontoller with 5V tollerant DIO that supports a hardware or software SPI interface (see example Arduino sketch below)
PINOUT:
1...VCC
2...N/A
3...MISO
4...MOSI
5...SCK
6...CS
7...N/A
8...N/A
Example Arduino sketch available on our support forum here.
Specific References
16 other products in the category
40 Tooth Extruder Gear
This 26 tooth extruder gear measures approximately 11mm in diameter (toothed end) and has a...
70CM Female to Female...
These long 70CM female to female dupont cables sold in 2, 3, and 4 way versions are great for...
RepRap PCB Heat bed MK2a...
The MK2a version of the heat bed PCB has a central mounting hole on the front...
- Currently Out of Stock
7mm Drag Chain
This 7mm drag chain helps to maintain the life of wires used in numerous machines, including...
RAMPS compatible LCD...
This controller is designed to be used with a RepRap RAMPS interface board such as our RAMPS...
26 Tooth Extruder Gear
This 26 tooth extruder gear measures approximately 11mm in diameter (toothed end) and has a...
High quality 24V / 40W...
A 40W heater cartridge suitable for 3D printers (e.g. Reprap Mendel Prusa) with a 24V supply....
V1.2 Mechanical End stop...
These mechanical end stops are quiet simply a means to an end. They detect when an x/y/z stage...
70CM Female to Female...
These long 70CM female to female dupont cables sold in 2, 3, and 4 way versions are great for...
High quality 12V / 40W...
A 40W heater cartridge suitable for 3D printers (e.g. Reprap Mendel Prusa) with a 12V supply....
- Currently Out of Stock
Brass 3D printer nozzle...
Brass nozzle for common types of 3D printer a6 a8 MK8 Extruder Makerbot 3d etc. Accepts 1.75mm...
- Currently Out of Stock
M6 Heat Break Hotend Throat...
High temperature stainless steel 3D printer heat break suitable for 1.75mm fulfillment. This...
40mm x 40mm Brushless DC Fan
This 40mm x 40mm fan has a height of 10mm. The rated voltage is 5V with a startup of 2.8V....
RepRap Mega Pololu...
RepRap Arduino Mega Pololu Shield, or RAMPS for short. It is designed to fit the entire...
- Currently Out of Stock