MK2B RAMPS Compatible Dual Power 12/24V Heatbed
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It has a central mounting hole on the front side to allow for three point mounting.
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It has a central mounting hole on the front side to allow for three point mounting. This is much easier for bed levelling in comparison to 4 point mounting. Additionally, the solder pads have been greatly increased in size, making it much easier and allowing for the use of 1206 surface mount components. Please note however, that this does not remove the need to use proper strain relief. We also supply suitable surface mount LED's and resistor as an option.
Specification:
Dimensions (Outer): 214mm x 214mm
Dimensions (Heat Bed): 200mm x 200mm
Resistance (12V): 0.9 - 1.6 Ohms
Resistance (24V): 3.5 - 5.9 Ohms
Operating voltage: 12 or 24 Volts
Operating current (12V): 7.4 - 12.7 Amps
Operating current (24V): 4.1 - 6.6 Amps
Wattage (Typ): 115W (12V) / 120W (24V)
Specific References
16 other products in the category
V1.2 Mechanical End stop...
These mechanical end stops are quiet simply a means to an end. They detect when an x/y/z stage...
Stepper Motor Driver HR4988
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
70CM Female to Female...
These long 70CM female to female dupont cables sold in 2, 3, and 4 way versions are great for...
10mm Drag Chain
This 10mm drag chain helps to maintain the life of wires used in numerous machines, including...
40mm x 40mm Brushless DC Fan
This 40mm x 40mm fan has a height of 10mm. The rated voltage is 5V with a startup of 2.8V....
High quality 24V / 40W...
A 40W heater cartridge suitable for 3D printers (e.g. Reprap Mendel Prusa) with a 24V supply....
RepRap PCB Heat bed MK2a...
The MK2a version of the heat bed PCB has a central mounting hole on the front...
- Currently Out of Stock
RepRap Mega Pololu...
RepRap Arduino Mega Pololu Shield, or RAMPS for short. It is designed to fit the entire...
- Currently Out of Stock
7mm Drag Chain
This 7mm drag chain helps to maintain the life of wires used in numerous machines, including...
MK7/MK8 Heatsink (Black)
This extruder heatsink measures 40mm x 40mm and is 11mm deep. The centre hole is approximately...
microSD card reader module...
A microSD card reader module with built in 3.3V level shifter which allows safe interfacing to...
MK7 Compatible Extrusion...
3d printer MK7 compatible stainless steel extrusion gear for 1.75mm filament. Includes grub...
High quality 12V / 40W...
A 40W heater cartridge suitable for 3D printers (e.g. Reprap Mendel Prusa) with a 12V supply....
- Currently Out of Stock
100k Thermistor
A thermistor is a type of resistor whose resistance varies significantly with temperature,...