PT100 Temperature Probe PTR...
This Platinum thermal resistance probe is an accurate, sensitive, and stable temperature...
This module has been designed as an alternative to the PIR motion detectors commonly used in burglar alarms. Instead of sensing changes in infrared radio emitted by a moving person this sensor uses a microwave Doppler radar to detect moving objects. It has a sensitivity range of ~7 meters. When triggered its trigger output pin will switch from...
This module has been designed as an alternative to the PIR motion detectors commonly used in burglar alarms. Instead of sensing changes in infrared radio emitted by a moving person this sensor uses a microwave Doppler radar to detect moving objects. It has a sensitivity range of ~7 meters. When triggered its trigger output pin will switch from (LOW) 0V to high (3.3V) for ~ 2 to 3 seconds before returning to its idle LOW state.
Features:
Product code: HCSENS0040
Supply Voltage: 5V dc
Supply Current: >3mA (2.8mA typical)
Operating frequency: ~3.2GHz
Transmit power: 20mW (typical) / 30mW (max)
Size: 36mm x 17mm
Notes:
Component side should face detection area for maximum sensitivity
Do not place metal objects within 1cm of antenna
Trigger out - HIGH (3.3V) motion / LOW no motion
3.3V output is for reference only - do not use to power other devices.
Device operates at ~3.2GHz/20 - 30mW. In some countries it may be illegal to operate this device.
Pinout:
3V3..........Regulated output (reference only)
GND.........Ground / 0V supply input
OUT..........Trigger: HIGH (3.3V) motion detected / LOW (0V) idle
VIN.......... 5V-12V supply input
CDS..........Sensor disable input (pull low to disable)
This Platinum thermal resistance probe is an accurate, sensitive, and stable temperature...
A very low cost module incorporating with a very high precision 24 ADC and differential high...
LD2410C is a high-sensitivity 24GHz human presence status sensing module developed by Hi-link....
The MAX471 module (HCSENS0041) is a complete, bidirectional, highside current-sense amplifier...
The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
This water level sensor / float switch can be used to sense when a liquid has reached a set...
This module (HCMODU0099) is a breakout board for the Texas Instruments ADS1015 ADC. This...
- Photosensitive diode
- Working power: + 5V
- Working current: < 10mA
-...
A simple but very useful module which uses a potential divider to reduce any input
The Aosong AM2315 is a wall mountable temperature and humidity sensor (HCSENS0043) based on...
This strain gauge module uses a BF350 sensor to measure mechanical stresses in solid...