Side mounted water level /...
A side mounted waterproof float switch (HCSENS0015) which uses a magnet embedded in the float,...
This module (HCMODU0099) is a breakout board for the Texas Instruments ADS1015 ADC. This device provides a precision 12 bit analogue to digital (ADC) resolution. Designed with precision, low power and ease of implementation in mind. The ADS1015 features onboard reference and an oscillator. A serial I2C interface allows interfacing to the module with only...
This module (HCMODU0099) is a breakout board for the Texas Instruments ADS1015 ADC. This device provides a precision 12 bit analogue to digital (ADC) resolution. Designed with precision, low power and ease of implementation in mind. The ADS1015 features onboard reference and an oscillator. A serial I2C interface allows interfacing to the module with only two pins and it's slave address can be configured on one of four addresses, allowing for multiple modules to be connected to one I2C bus. The ADS1015 can perform conversions at rates up to 3300 samples per second (SPS). An onboard PGA is available that offers input ranges from the supply to as low as ±256mV, allowing both large and small signals to be measured with high resolution. The ADS1115 also features an input multiplexer (MUX) that provides two differential or four single-ended inputs.
The ADS1015 operates either in continuous conversion mode or a single-shot mode that automatically powers down after a conversion and greatly reduces current consumption during idle periods.
Features:
• WIDE SUPPLY RANGE: 2.0V to 5.5V
• LOW CURRENT CONSUMPTION: Continuous Mode: Only 150μA Single-Shot Mode: Auto Shut-Down
• PROGRAMMABLE DATA RATE: 128SPS to 3300SPS
• INTERNAL LOW-DRIFT VOLTAGE REFERENCE
• INTERNAL OSCILLATOR
• INTERNAL PGA
• I2C™ INTERFACE: Pin-Selectable Addresses
• FOUR SINGLE-ENDED OR TWO DIFFERENTIAL INPUTS
• PROGRAMMABLE COMPARATOR
A side mounted waterproof float switch (HCSENS0015) which uses a magnet embedded in the float,...
Compatible with DS18B20. Please note that this sensor does not support parasitic mode.
...The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
This infra-red reflecting sensor module (HCSENS0016) is ideal for application were reflective...
This 5mW laser module emits a small intense focused beam of visible red light. The example...
This module (HCMODU0098) is a breakout board for the Texas Instruments ADS1115 ADC. This...
This water sensor is designed for water detection and can be widely used in sensing rainfall...