We will be closed from 24th December to 3rd January. However we will be dispatching orders throughout this period when the postal service is in operation.
We would like to wish all our customers, old and new, a very merry Christmas.
Yodel
Please note: Yodel is currently experiencing issues. Whilst the issue is ongoing, orders placed using this service will be dispatched via Evri or Royal Mail 48 hour service.
The Pro Micro is similar to the Pro Mini, except for the fact that it utilises the ATMega32U4. Additionally, there is an on-board USB transceiver inside the 32U4, which removes the need for a bulky external USB interface. There is also a voltage regulator on-board which means it can accept up to 12V DC. Please bear in mind that if supplying unregulated power, you need to connect to...
The Pro Micro is similar to the Pro Mini, except for the fact that it utilises the ATMega32U4. Additionally, there is an on-board USB transceiver inside the 32U4, which removes the need for a bulky external USB interface. There is also a voltage regulator on-board which means it can accept up to 12V DC. Please bear in mind that if supplying unregulated power, you need to connect to “RAW”, not “VCC”.
The pro micro is available to two versions, 3.3V and 5V. This listing is for the 3.3V version:
3.3V Version:
Product Code: HCDVBD0024
Supply voltage (VCC): 3.3V
Supply voltage (RAW): 3.6V - 12V
Frequency: 8MHz
Dimensions: 1.3 x 0.7"
Features:
• ATMega 32U4 running at 5V/16MHz or 3.3V/8MHz (depending on version)
• Supported under Arduino IDE
• On-Board micro-USB connector for programming
• 4 x 10-bit ADC pins
• 12 x Digital I/Os (5 are PWM capable)
• Rx and Tx Hardware Serial Connections
This product is manufactured by Deek-Robot and is derived from the SparkFun(TM) Pro Mini reference design which was released under the Creative commons Attribution-ShareAlike 3.0 licence.
https://creativecommons.org/licenses/by ... /legalcode
Additional information, including a schematic, and modified blink sketch is available on our support forum here.
Our very own version of the popular Arduino Mega development board (HCARDU0092). It hast been...
The Open Smart One R3 is an Arduino Uno (R3) compatible development board. It uses the same...
This Arduino compatible board is specifically designed to drive a 3 colour RGB LED dot matrix...
The Arduino Due is a microcontroller board based on the Atmel SAM3X8E ARM Cortex-M3 CPU (
£16.99
Building your own hardware is always fun especially when it's combined with the Arduino...
This is our lower cost alternative to the standard R3 Uno, but in this case lower cost doesn't...
The Arduino Leonardo is a microcontroller board based on the ATmega32u4. It has 20 digital...
The Arduino Pro Mini is a microcontroller board based on the ATmega328. It...
The Arduino Nano is a small, complete, and breadboard-friendly board based on the ATmega328....
The Pro Micro is similar to the Pro Mini, except for the fact that it utilises the ATMega32U4....
The Pro Micro is similar to the Pro Mini, except for the fact that it utilises the ATMega32U4. Additionally, there is an on-board USB transceiver inside the 32U4, which removes the need for a bulky external USB interface. There is also a voltage regulator on-board which means it can accept up to 12V DC. Please bear in mind that if supplying unregulated power, you need to connect to...
