This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources (these are soldered for use as a 12V PCB). It has a central mounting hole on the front side to allow for three point mounting...
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources (these are soldered for use as a 12V PCB). It has a central mounting hole on the front side to allow for three point mounting. This is much easier for bed levelling in comparison to 4 point mounting. Additionally, the solder pads have been greatly increased in size, making it much easier and allowing for the use of 1206 surface mount components, which have already been soldered for you. The power cables are also already soldered into place. Please note however, that this does not remove the need to use proper strain relief.
Specification
Dimensions (Outer): 214mm x 214mm
Dimensions (Heat Bed): 200mm x 200mm
Resistance (12V): 0.9 - 1.6 Ohms
Resistance (24V): 3.5 - 5.9 Ohms
Operating voltage: 12 or 24 Volts
Operating current (12V): 7.4 - 12.7 Amps
Operating current (24V): 4.1 - 6.6 Amps
Wattage (Typ): 115W (12V) / 120W (24V)
HEATMAP is available on our support forum here.
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B...
These long 70CM female to female dupont cables sold in 2, 3, and 4 way versions are great for...
These long 70CM female to female dupont cables sold in 2, 3, and 4 way versions are great for...
A thermistor is a type of resistor whose resistance varies significantly with temperature,...
The MK2a version of the heat bed PCB has a central mounting hole on the front...
Excellent for 3D printer heatbeds, this leveling screw set comprises M3 leveling screw...
This controller is designed to be used with a RepRap RAMPS interface board such as our RAMPS...
Optical endstop providing a contactless and reliable alternative to the mechanical...
A 40W heater cartridge suitable for 3D printers (e.g. Reprap Mendel Prusa) with a 12V supply....
These mechanical end stops are quiet simply a means to an end. They detect when an x/y/z stage...
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
3d printer MK7 compatible stainless steel extrusion gear for 1.75mm filament. Includes grub...
This 40mm x 40mm fan has a height of 10mm. The rated voltage is 5V with a startup of 2.8V....
RepRap Arduino Mega Pololu Shield, or RAMPS for short. It is designed to fit the entire...
This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources (these are soldered for use as a 12V PCB). It has a central mounting hole on the front side to allow for three point mounting...
