The ULN2003 Stepper Motor Driver Board uses a ULN2003 IC to drive 4-phase, 5-wire stepper motors.
Supply Voltage: 5V (Supplied motor suitable for 5V applications)
Max Output Current: 0.5A (Single Output)
4 LED indicators
Size: 40.5mm x 21.3mm
Stepper Motor Cable Length (approx.): 24cm
Holding Torque: 0.3kg/cm
Diameter: 28mm
Step Angle: 5.625 degrees
Reduction Ratio: 1/64
The ULN2003 Stepper Motor Driver Board uses a ULN2003 IC to drive 4-phase, 5-wire stepper motors.
Supply Voltage: 5V (Supplied motor suitable for 5V applications)
Max Output Current: 0.5A (Single Output)
4 LED indicators
Size: 40.5mm x 21.3mm
Stepper Motor Cable Length (approx.): 24cm
Holding Torque: 0.3kg/cm
Diameter: 28mm
Step Angle: 5.625 degrees
Reduction Ratio: 1/64
Pinout
Example Arduino Sketch available on our support forum here.
A tiny vibrating DC motor measuring just 8 x 5mm (excluding shaft). Ideal for various...
A larger version of our standard Nema 17 type stepper motor. This stepper motor (HCROBO0051)...
Standard low voltage '130' type DC motor with two solderable terminals.
This item is an electrically operated fail secure latch type lock. It uses a solenoid...
The MG946R Servo is a popular high speed, high torque metal gear digital servo providing...
A small low profile, low power 5V DC motor with a no load rotational speed of 5600 RPM and no...
This N20 motor is has a 6V supply voltage and comes complete with a built-in metal gear box....
The DS05-NFC high torque servo (HCROBO0050) is able to rotate continuously in full 360...
These propellers measure 4cm (40mm). The fixed aperture in the centre measures approximately...
MG90S is a metal geared version of the extremely popular MG90 9g servo. The servo has a...
This N20 micro geared motor comes complete with a purpose designed friction fit wheel....
The ULN2003 Stepper Motor Driver Board uses a ULN2003 IC to drive 4-phase, 5-wire stepper motors.
Supply Voltage: 5V (Supplied motor suitable for 5V applications)
Max Output Current: 0.5A (Single Output)
4 LED indicators
Size: 40.5mm x 21.3mm
Stepper Motor Cable Length (approx.): 24cm
Holding Torque: 0.3kg/cm
Diameter: 28mm
Step Angle: 5.625 degrees
Reduction Ratio: 1/64
