LCD Keypad Shield for...
This shield (HCARDU0014) is designed for 5V Arduino boards that use the standard Arduino...
- On sale!
The Hoby Components high power motor drive shield (MonsterMoto compatible) is based on the Sparkfun reference design and uses two ST Microlectronics VNH2SP30-E full bridge high power motor drivers to independently control the speed and direction of two DC motors. The pinout of the shield means that each motor can be di...
The Hoby Components high power motor drive shield (MonsterMoto compatible) is based on the Sparkfun reference design and uses two ST Microlectronics VNH2SP30-E full bridge high power motor drivers to independently control the speed and direction of two DC motors. The pinout of the shield means that each motor can be directionally controlled with two DI0 pins, and its speed easily controlled using a single Arduino analogWrite() command (see our exclusive sketch in our support forum).
Specification:
Max motor supply voltage: 16V
Max instantaneous current: 30A*
Max continuous current: 14A*
Max PWM frequency: 20KHz
Current sensing linked to Arduino analogue pins
On-resistance: 19 mΩ (per leg)
Safety shut-down features including thermal overload, under and over voltage protection
PLEASE NOTE: When using the shield at its maximum current and voltage specifications, additional heat sinks may be required
Sketch and download available after purchase.
This shield (HCARDU0014) is designed for 5V Arduino boards that use the standard Arduino...
A 4 channel relay shield (HCARDU0102) which conveniently and safely allows an Arduino to...
This shield (HCARDU0086) is designed to allow you to control a...
This Screw Shield is a terminal expansion board which can be stacked directly on the female...
Plugs directly into an Arduino MEGA with no soldering required.
This Arduino compatible screw shield allows for easy and more durable interfacing to your...
This Arduino Uno and Leonardo compatible multifunction experimenter shield (HCARDU0085) has a...
- Arduino Protoytpe Shield:
- 2 general LEDs
- 2 switches
- Mini...
This feature rich 262K colour TFT module (HCARDU0097) has a resolution 320 x 240 pixels (QVGA)...
This shield is compatible with most types of Arduino boards that support the standard header...
The Hobby Components breakout shield is a quick and low cost way to add extra pin access to...
This adapter board shield (HCARDU0098) is intended to be used with our 3.2" TFT touch screen...
This Ethernet Shield is based on the Wiznet W5100 Ethernet Chip and gives you an easy way to...
This adapter board shield (HCARDU0084) is intended to be used with our 2.4" TFT touch screen...
2 interfaces for 5V Servo connected to Arduino's high-resolution dedicated...