mLink L9110 DC Motor...
The mLink L9110 motor controller is a serial (I2C) 2 channel DC motor driver that is capable...
£6.99
Hobby Components breakout shield
£4.99
VAT included
The Hobby Components breakout shield is a quick and low cost way to add extra pin access to the standard headers provided on Arduino development boards. Using this breakout shield you can connect up to 3 (see notes below) additional devices to each I/O pin of your Arduino and it also breaks out the power and GND pins for powering multiple modules and circuits.
The Hobby Components breakout shield is a quick and low cost way to add extra pin access to the standard headers provided on Arduino development boards. Using this breakout shield you can connect up to 3 (see notes below) additional devices to each I/O pin of your Arduino and it also breaks out the power and GND pins for powering multiple modules and circuits. Compatible with any Arduino board that includes the standard Arduino headers - e.g. Uno, Leonardo, Mega.
Please note:
This item is supplied in kit form and requires soldering.
When using this expansion shield to drive more than one circuit from the output of an Arduino pin do not exceed the maximum current sink or source capacity of the Arduinos digital output pin.
DO NOT use this expansion shield to connect more than one digital signal to the input of an Arduino pin.
Kit contents:
1x Breakout PCB
1x 10 pin male to female header
2x 8 pin male to female headers
1x 6 pin male to female header
3x 40 pin breakable male to male headers
HCARDU0110
22 Items
Specific References
16 other products in the category
SmartRFy USB Module
The SmartRFy USB module adds the ability to monitor and control a SmartRFy network directly...
£8.99
- Currently Out of Stock
4x4x4 Cube PCB V2 Template
Additional add-on for our V2 4x4x4 Cube Kits. This PCB template has been designed to make...
£1.49
Hobby Components Arduino...
Our very own version of the popular Arduino Mega development board (HCARDU0092). It hast been...
£17.99
- Currently Out of Stock
SmartRFy Digital Tx Module
The SmartRFy digital Tx module provides a set of 4 digital input pins which can be used to...
£3.99
Hobby Components Uno...
The Hobby Components prototyping shield for the Arduino Uno allows you to add your own custom...
£3.99
- Currently Out of Stock
mLink 12Bit I2C Digital...
The mLink port expander is a serial (I2C/IIC) digital I/O module. It allows you to add 12...
£2.99
Hobby Components Obstacle...
This robotic car kit is a complete kit of parts, including electronics, that will allow you to...
£19.99
- Currently Out of Stock
Hobby Components 16 Channel...
The Hobby Components logic analyser can capture up to 16 separate channels of 3.3V or 5V logic...
£22.99
- Currently Out of Stock
Hobby Components Starter...
PLEASE NOTE THAT THIS KIT IS NOW SHIPPED WITH OUR UNO+ Development Board (See SKU:...
£24.99
Hobby Components Uno Plus
This is our lower cost alternative to the standard R3 Uno, but in this case lower cost doesn't...
£6.99
The Hobby Components breakout shield is a quick and low cost way to add extra pin access to the standard headers provided on Arduino development boards. Using this breakout shield you can connect up to 3 (see notes below) additional devices to each I/O pin of your Arduino and it also breaks out the power and GND pins for powering multiple modules and circuits.