Product Description
K150 is a low-cost high-performance PIC programmer, supporting the most popular PIC chips. Allows reading, writing, encryption, and uses high-speed USB communication for fast programming ( speed average PICSTART + 3-5 times ). Fully automatic programming checksum ; equipped with 40pin DIP programming ZIF socket, di...

Datasheet is available on our support forum here.

Please note that the manufacturer of this chip is subject to change.

100pcs total.

These devices are precision timing circuits capable of producing accurate time delays or oscillation. In the time-delay or monostable mode of operation, the timed interval is controlled by a single external resistor and capacitor network.

Datasheet is available on our support forum here.

Please note that the manufacturer of this chip is subject to change.

Number of Pins: 28

Socket Type: DIL 0.3 Inch

USB to RS232 TTL PL2303HX auto converter module adapter with a 5V output, which provides the most convenient way to connect your RS232 TTL devices to your computer via the USB port. The cable has a built-in TTL COM PC-PL2303HX Chip and uses a standard USB type A male and TTL 4 pin connector. The cable length is approximately 100cm in length.

The ULN2803APG / AFWG Series are high−voltage, high−current darlington drivers comprised of eight NPN darlington pairs. All units feature integral clamp diodes for switching inductive loads. Applications include relay, hammer, lamp and display (LED) drivers.

Datasheet is available on our support forum here.

Please note that the manufacturer of this chip is subject to change.

These 125KHz RFID key fobs are idea for use as general purpose RFID tags or for use with with our RFID door access system (HCRFID0002). Each fob has a unique serial number therefore no programming is required to use them. The fob is constructed from hard wearing ABS plastic. This is a pack of 5.

A 12mm diameter miniature PCB mounted passive speaker ideal for projects where a multi toned sound is required.

Min voltage: 1.5V
Max voltage: 5V
Coil resistance: 16 Ohms
Diameter: 12mm
Height above PCB: 8.4mm

The µA741 device is a general-purpose operational amplifier featuring offset-voltage null capability.

The high common-mode input voltage range and the absence of latch-up make the amplifier ideal for voltage-follower applications. The device is short-circuit compensation components. A low value potentiometer may be connected between the offset null inputs to null out the offset voltage.

This pulse generator module is intended to be interfaced with common types of stepper / motor controllers. The module has two modes of operation, frequency and PWM. In frequency mode it will generate a square wave signal at a frequency that can b...