BF350-3AA Strain Gauge Module
This strain gauge module uses a BF350 sensor to measure mechanical stresses in solid...
£4.99
- Currently Out of Stock
Hall effect magnetic sensor module
£1.49
£2.49
VAT included
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND) when a magnetic field is detected. An on board LED will also...
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND) when a magnetic field is detected. An on board LED will also indicate the presence of a magnetic field.
Pinout
PIN 1: GND
PIN 2: +5V
PIN 3: DATA OUT
Example Arduino Sketch available after purchase.
HCSENS0021
23 Items
Specific References
16 other products in the category
Optical endstop for 3D...
Optical endstop providing a contactless and reliable alternative to the mechanical...
£2.49
KY-040 Rotary Encoder Module
Working voltage: 5V
Circle of Pulses: 20
Product Code: HCMODU0063
Diagrams,...
£2.49
Photoresistive light...
Photoresistive light dependent resistor module. Keyes brand KY-018. This module allows for...
£1.69
PIR and Bracket Bundle
The perfect accompaniment to our Pyroelectric Infrared PIR Motion Sensor Detector Module...
£2.99
Waterproof DS18B20...
DS18B20 temperature sensor chip, waterproof, stainless steel probe, cable length: 100cm; Power...
£2.99
- Currently Out of Stock
BF350-3AA Strain Gauge Sensor
A resistive strain gauge sensor with a 350 ohm nominal resistance which varies when a force is...
£1.29
Gas Sensor (MQ2)
The MQ2 analogue gas sensor is used in gas leakage detection equipment in consumer and...
£3.98
ADS1115 I2C 16Bit ADC Module
This module (HCMODU0098) is a breakout board for the Texas Instruments ADS1115 ADC. This...
£6.49
KY-008 650nm 5V Laser Module
This 5mW laser module emits a small intense focused beam of visible red light. The example...
£0.99
MQ 7 Carbon Monoxide Sensor...
The MQ-7 carbon monoxide sensor module allows for the sensing of CO concentrations in the air....
£2.49
- Currently Out of Stock
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND) when a magnetic field is detected. An on board LED will also...