Side Mounted Water Level /...
This water level sensor / float switch can be used to sense when a liquid has reached a set...
- On sale!
A resistive strain gauge sensor with a 350 ohm nominal resistance which varies when a force is applied. By measuring the change in the sensors resistance a measurement of the force applied to it can be obtained. Note that strain gauges exhibit small changes in resistance and so this sensor should be used in a Wheatstone bridge...
A resistive strain gauge sensor with a 350 ohm nominal resistance which varies when a force is applied. By measuring the change in the sensors resistance a measurement of the force applied to it can be obtained. Note that strain gauges exhibit small changes in resistance and so this sensor should be used in a Wheatstone bridge configuration. If using with a microcontroller such as an Arduino we also recommend using our HX711 digital bridge sensor interface module (see SKU HCMODU0073). Alternatively, if only relative measurements are required please see our analogue strain gauge module (see SKU HCSENS0036) which includes this sensor and can be connected directly to a microcontrollers ADC input.
Nominal resistance(Ohm): 350
Tolerance: <±0.1%
Gauge factor: 2.00~2.20
Gauge factor resistance: <±1%
Strain limit: 2.0%
Fatigue life: >10
Metal foil: constantan alloy
Working temperature range: -30~+80℃
Temperature compensation: Aluminium(23)
Gauge Grid(mm) Dimensions(L×M): 3.2 x 3.06
Gauge Creep Code: M6 to O6
Example Application:
This water level sensor / float switch can be used to sense when a liquid has reached a set...
Compatible with DS18B20. Please note that this sensor does not support parasitic mode.
...The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
This module (HCMODU0098) is a breakout board for the Texas Instruments ADS1115 ADC. This...
A linear sliding potentiometer module allowing for very smooth and precise control. The module...
The GP2Y1010AU0F / GP2Y1014AU (HCSENS0024) from Sharp is an optical air quality sensor,...
This is a very low cost break out module for the ADXL335 tripple axis accelerometer. This...
LD2410C is a high-sensitivity 24GHz human presence status sensing module developed by Hi-link....
A breakout board for the TCS320 colour sensor which also includes white LEDs for reflective...
Photoresistive light dependent resistor module. Keyes brand KY-018. This module allows for...
The MAX471 module (HCSENS0041) is a complete, bidirectional, highside current-sense amplifier...
A capacitive touch sensor module based on the dedicated TTP223 touch sensor IC. The module...
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND)...
The perfect accompaniment to our Pyroelectric Infrared PIR Motion Sensor Detector Module...