TELEPHONE LINES | Unfortunately due to the level of orders we are currently experiencing, we aren't always able to answer calls. If your query is urgent, please do leave a message or email sales@hobbycomponents.com and we will get back to you as soon as we are able. |
New products
New products
Motor Drive Shield L293D for Arduino
2 interfaces for 5V Servo connected to Arduino's high-resolution dedicated timer
- 2 interfaces for 5V Servo connected to Arduino's high-resolution dedicated timer - no jitter!
- Can drive 4 DC motors, 2 stepper motors or 2 Servo
- Up to 4 bi-directional DC motors with individual 8-bit speed selection
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
- 4 H-Bridges: each bridge provides 0.6A (1.2A peak current) with thermal protection and can run motors on 4.5V to 36V DC
- Pull down resistors keep motors disabled during power-up
- Reset button
- 2 external terminal power interface, for separate logic/motor supplies
- Tested compatible for Arduino Mega, Diecimila & Duemilanove
L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means that using this chip you can use DC motors and power supplies of up to 36 Volts. The chip can supply a maximum current of 600mA per channel, the L293D chip is also what’s known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.