Description:
This module uses the L293D chip and can drive 4 DC motors, and there is a 2 channel stepper motor port
Driver chips: L293D Dual H-Bridge Motor Driver IC
Drive part of the input voltage ...
Description:
This module uses the L293D chip and can drive 4 DC motors, and there is a 2 channel stepper motor port
Driver chips: L293D Dual H-Bridge Motor Driver IC
Drive part of the input voltage Vdd: +5 V ~ +16 V
Drive part peak current Io: 1A
Drive part continuous current: 600mA
Logical part of the operating current range: 0 ~ 36mA
Control signal input voltage range (IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8): Low: -0.3V ≤ Vin ≤ 1.5V High: 2.3V ≤ Vin ≤ Vss
Enable signal input voltage range (EN1 EN2 EN3 EN4): Low: -0.3V ≤ Vin ≤ 1.5V (control signal is invalid) High: 2.3V ≤ Vin ≤ Vss (control signal active)
Maximum power consumption: 20W (when the temperature T = 25 Celsius )
Drive Type: Dual high-power H-bridge driver
Size: 90mm × 37mm
This pulse generator module is intended to be interfaced with common types of stepper / motor...
This module is based upon the Allegro A4988 stepper motor driver and is ideal for use in 3D...
An Arduino compatible stepper motor driver shield. This shield makes use of 2x Allegro A3967...
This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...
This is a square wave pulse generator module based on the ubiquitous NE555 timer IC. The...
This item (HC3DPR0038) is a breakout out / adapter board for the low cost A4988 stepper motor...
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This...
A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S...
This EasyDriver compatible stepper motor driver module utilises the Allegro A3967SLB...
Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface,...
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
This little module (HCMODU0083) is a breakout board for the IFR520 MOSFET transistor. The...
Description:
This module uses the L293D chip and can drive 4 DC motors, and there is a 2 channel stepper motor port
Driver chips: L293D Dual H-Bridge Motor Driver IC
Drive part of the input voltage ...
