Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface, power for 5V single-chip circuitry, supports 3.3VMCU control
- Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface, power for 5V single-chip circuitry, supports 3.3VMCU control
- Can easily control the DC motor speed and direction, can also control a 2-phase stepper motor
- Driver: L298N Dual H Bridge DC Motor Driver IC
- Driven part of the terminal supply voltage: VMS 5~35V
- Driven part of the peak current Io: 2A per bridge
- The logical part of the terminal supply voltage: 4.5~7V
- The logical part of the operating current range: 0 ~ 36mA
- Control signal input voltage range: 4.5~5.5V (high) / 0V (low)
- Maximum power consumption: 20W
This little module (HCMODU0083) is a breakout board for the IFR520 MOSFET transistor. The...
A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S...
This EasyDriver compatible stepper motor driver module utilises the Allegro A3967SLB...
This item (HC3DPR0038) is a breakout out / adapter board for the low cost A4988 stepper motor...
The mLink 12-Channel Servo Controller allows you to independently control up to 12 servos per...
This pulse generator module is intended to be interfaced with common types of stepper / motor...
This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This...
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
This is a square wave pulse generator module based on the ubiquitous NE555 timer IC. The...
Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface, power for 5V single-chip circuitry, supports 3.3VMCU control