We will be closed from 24th December to 3rd January. However we will be dispatching orders throughout this period when the postal service is in operation.
We would like to wish all our customers, old and new, a very merry Christmas.
Yodel
Please note: Yodel is currently experiencing issues. Whilst the issue is ongoing, orders placed using this service will be dispatched via Evri or Royal Mail 48 hour service.
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This driver allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino...
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This driver allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino. Alternatively, the module is capable of driving a single 4 input stepper motor. It includes an optional on-board 5V regulator for powering its internal logic circuit so only one supply voltage is required (Vm = 6 to 12V). Screw terminals allow for easy connection of the motor(s) and the power supply.
Specification:
Product code: HCROBO0068
Motor input voltage (Vm): 5 – 24V
Combined motor drive current (max): 2A for 2 minutes / 1A continuous
5V output current (J1 fitted): 100mA
Dimensions: (LxWxH): 43mm x 43mm x 27.5mm
Notes:
When J1 is fitted the input of the on-board 5V regulator is connected to Vm and the 5V terminal becomes an output. If J1 is removed a separate 5V supply connected to the 5V terminal is required to power the digital circuit.
Actual voltage across motor terminals = Vm - ~2.35V
(!) When using the 5V terminal as an output (J1 fitted) DO NOT draw more than 100mA from this terminal.
(!) For Vm voltages > 12V jumper J1 must be removed and a separate 5V supply connected the 5V terminal.
Failure to observe the above conditions will result in permanent damage to the on-board regulator resulting in the motor supply voltage Vm being applied to the 5V terminal.
This pulse generator module is intended to be interfaced with common types of stepper / motor...
This module is based upon the Allegro A4988 stepper motor driver and is ideal for use in 3D...
This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...
This item (HC3DPR0038) is a breakout out / adapter board for the low cost A4988 stepper motor...
This little module (HCMODU0083) is a breakout board for the IFR520 MOSFET transistor. The...
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface,...
This EasyDriver compatible stepper motor driver module utilises the Allegro A3967SLB...
This is a square wave pulse generator module based on the ubiquitous NE555 timer IC. The...
A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S...
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This driver allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino...