Pulse / PWM generator for stepper motor drivers

£11.99
VAT included

This pulse generator module is intended to be interfaced with common types of stepper / motor controllers. The module has two modes of operation, frequency and PWM. In frequency mode it will generate a square wave signal at a frequency that can b...

Quantity
block Currently Out of Stock

This pulse generator module is intended to be interfaced with common types of stepper / motor controllers. The module has two modes of operation, frequency and PWM. In frequency mode it will generate a square wave signal at a frequency that can be controlled by the user via a large potentiometer dial. In this mode there are 3 frequency ranges which can be selected by a jumper (see below). In PWM mode the module will generate a pulse width modulated signal with a duty cycle set by the potentiometer. There are also two latching switches that allow a user to enable/disable the motor output, and a motor direction control. The module also has two power input ranges allowing it to be powered from a very broad power supply range. 

Please note: This module is intended to be used in conjunction with a motor driver, it cannot be used for driving a stepper motor directly. When using the 12V to 160V supply input option,the 5V to 12V terminal must be left disconnected. 


Connections:

Image

HCMODU0062

Specific References

12 other products in the category

PCA9685 16ch 12bit PWM/Servo controller Module

PCA9685 16ch 12bit...

This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...

£6.29
zoom_in
  • Currently Out of Stock