• L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS
  • L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS
  • L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS
  • L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS
  • L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS
  • L9110S DC Stepper Motor Driver H-Bridge for Arduino 2.5-12v 800mA TTL/CMOS

L9110S DC Stepper Motor Driver H-Bridge

£1.99
VAT included

A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply...

Quantity
check In Stock

A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply range to be controlled safely from a standard microcontroller. Maximum drive current is 800mA. 0.1" pitch header pins allow for direct connection to a microcontoller such as an Arduino requiring just two digital pins per DC motor for control in both directions. Screw terminal blocks provide convenient connection to the motors(s).



- Dual L9110S chipset motor driver

- Input voltage: 2.5V~12V
- Current: 800mA
- Can drive two DC motors, and a 4-wire 2-phase stepper motor



HCMODU0033
54 Items

Specific References

13 other products in the category

PCA9685 16ch 12bit PWM/Servo controller Module

PCA9685 16ch 12bit...

This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...

£6.29
zoom_in
  • Currently Out of Stock