This is a simple photosensitive resistance sensor module. The sensor has a digital output that will go high if light is detected above a threshold set by the modules potentiometer. Additionally there is also an analogue output which will vary between 0 and 5V depending on the amount of light hitting the sensor.
This is a simple photosensitive resistance sensor module. The sensor has a digital output that will go high if light is detected above a threshold set by the modules potentiometer. Additionally there is also an analogue output which will vary between 0 and 5V depending on the amount of light hitting the sensor.
Exaple Arduino Sketch available here.
Pinout
This infra-red reflecting sensor module (HCSENS0016) is ideal for application were reflective...
This water sensor is designed for water detection and can be widely used in sensing rainfall...
This water level sensor / float switch can be used to sense when a liquid has reached a set...
A simple but very useful module which uses a potential divider to reduce any input
On-board ACS712T ELC-05B current sensor; Working voltage: DC 5V; Power LED indicator; Measures...
The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
The MAX471 module (HCSENS0041) is a complete, bidirectional, highside current-sense amplifier...
A capacitive touch sensor module based on the dedicated TTP223 touch sensor IC. The module...
Photoresistive light dependent resistor module. Keyes brand KY-018. This module allows for...
This module has been designed as an alternative to the PIR motion detectors commonly used in...
The DHT21 digital temperature sensor is one of the commonest from the range of DHT temperature...
This 5mW laser module emits a small intense focused beam of visible red light. The example...
The VL53L0X (HCMODU0127) is a new generation Time-of-Flight (ToF) laser-ranging module housed...
This is a simple photosensitive resistance sensor module. The sensor has a digital output that will go high if light is detected above a threshold set by the modules potentiometer. Additionally there is also an analogue output which will vary between 0 and 5V depending on the amount of light hitting the sensor.
