1.3" SH1106 uOLED Display Module (Blue)

A larger 1.3" version of our ultra low power tiny uOLED display module. This display has the same 128 x 64 pixel resolution of the smaller 0.96" module but has a significantly larger screen. The module also uses the SH1106 driver which provides a configurable serial interface. By default the display uses a standard SPI interface but it can be reconfigured to use I2C (soldering required). To get you up and running quickly we have also written an extensive Arduino library which will not only work with both sizes of display but will also allow you to drive multiple displays from one Arduino board. The display requires 5 digital pins with only 3 extra pins per additional display. 

Available in white pixel: HCMODU0058 or blue pixel: HCMODU0059 





Module size: 35.5x33.3mm
High pixel density
Resolution: 128X64 
Super wide viewing angle: more than 160°
Ultra-low power consumption: normal display 0.06W (far below the TFT display)
Wide supply range: DC 3V-5V (without any changes, directly compatible with common 3.3V and 5V power supply system)
Industrial grade: Operating temperature range -30 C ~ 70 C
Ultra-small size
Chip select CS signal allows for multiple SPI devices on the same bus.
Compatible tolerant interface.
OLED screen, internal driver chip: SH1106 
Pixel Colour: White (HCMODU0058), Blue (HCMODU0059)





1....GND: Power ground
2....VCC: 3.3V or 5V power supply
3....D0: CLK Clock
4....D1: MOSI data
5....RST: Reset
6....DC: data / command
7....CS: Chip select signal

Exclusive Library and example sketch available on our support forum, along with datasheet. Also, check out the fab alternative "Blink" sketch on our blog here!