1.8 Inch 128x64 ST7567...
This 1.8” LCD monochrome graphical display has a resolution of 128x64 pixels with pixel colour...
These tiny 0.96 inch uOLED displays have a resolution of 128 x 64 pixels and use a standard (SPI) serial interface for communication. Based on the SSD1306 controller, the module is available in both white and blue pixel colours. Pre-written libraries for Arduino are freely available including our own HCuOLED library for Arduino compatible development boards.
These tiny 0.96 inch uOLED displays have a resolution of 128 x 64 pixels and use a standard (SPI) serial interface for communication. Based on the SSD1306 controller, the module is available in both white and blue pixel colours. Pre-written libraries for Arduino are freely available including our own HCuOLED library for Arduino compatible development boards.
Module size: 27.3*27.8mm
High pixel density
Resolution: 128X64
Super wide viewing angle: more than 160°
Ultra-low power consumption: normal display 0.06W (far below the TFT display)
Wide supply range: DC 3V-5V (without any changes, directly compatible with common 3.3V and 5V power supply system)
Industrial grade: Operating temperature range -30 C ~ 70 C
Ultra-small size: (length) 27.8MM * (W) 27.3MM * (thickness) 4.3MM
Chip select CS signal allows for multiple SPI or IIC devices on the same bus.
Compatible tolerant interface.
OLED screen, internal drive chip: SSD1306
Pixel Colour: White (HCMODU0050), Blue (HCMODU0052)
1....GND: Power ground
2....VCC: 3.3V or 5V power supply
3....D0: CLK Clock
4....D1: MOSI data
5....RST: Reset
6....DC: data / command
7....CS: Chip select signal
This 1.8” LCD monochrome graphical display has a resolution of 128x64 pixels with pixel colour...
These tiny 0.9 inch uOLED displays have a resolution of 128 x 32 pixels and use a standard...
A 3.2" colour TFT display module compatible with 3.3V microcontrollers such as the Arduino...
This feature rich 262K colour TFT module (HCARDU0097) has a resolution 320 x 240 pixels (QVGA)...
This 8x8 serial dot matrix LED module (HCOPTO0014) allows you to experiment with dot matrix...
The mLink WS2812 LED driver is a serial (I2C) module intended for driving WS2812 5V RGB LEDs....
This 66mm module contains a strip of 16 individually controllable RGB LEDs arranged in a...
This 8 digit seven segment display module (HCMODU0095) uses a TM6138 controller allowing full...
The 2004 SmartLCD module is a serially controlled 4 line by 20 character alphanumeric LCD...
Red and green (common anode) 24 Pin 8x8 Dot Matrix Module
Please note that a current...
These tiny 0.96 inch uOLED displays have a resolution of 128 x...