Hobby Components SmartLCD...
The SmartLCD Keypad Kit is an optional add-on for the Hobby Components SmartLCD (HCMODU0122)....
These tiny 0.96 inch uOLED displays have a resolution of 128 x 64 pixels and use a standard (SPI) serial interface for communication. Based on the SSD1306 controller, the module is available in both white and blue pixel colours. Pre-written libraries for Arduino are freely available including our own HCuOLED library for Arduino compatible development boards.
These tiny 0.96 inch uOLED displays have a resolution of 128 x 64 pixels and use a standard (SPI) serial interface for communication. Based on the SSD1306 controller, the module is available in both white and blue pixel colours. Pre-written libraries for Arduino are freely available including our own HCuOLED library for Arduino compatible development boards.
Module size: 27.3*27.8mm
High pixel density
Resolution: 128X64
Super wide viewing angle: more than 160°
Ultra-low power consumption: normal display 0.06W (far below the TFT display)
Wide supply range: DC 3V-5V (without any changes, directly compatible with common 3.3V and 5V power supply system)
Industrial grade: Operating temperature range -30 C ~ 70 C
Ultra-small size: (length) 27.8MM * (W) 27.3MM * (thickness) 4.3MM
Chip select CS signal allows for multiple SPI or IIC devices on the same bus.
Compatible tolerant interface.
OLED screen, internal drive chip: SSD1306
Pixel Colour: White (HCMODU0050), Blue (HCMODU0052)
1....GND: Power ground
2....VCC: 3.3V or 5V power supply
3....D0: CLK Clock
4....D1: MOSI data
5....RST: Reset
6....DC: data / command
7....CS: Chip select signal
The SmartLCD Keypad Kit is an optional add-on for the Hobby Components SmartLCD (HCMODU0122)....
The mLink WS2812 LED driver is a serial (I2C) module intended for driving WS2812 5V RGB LEDs....
This 45mm module contains a strip of 16 individually controllable RGB LEDs arranged in a...
The 12864B Graphic LCD module is a 128 x 64 pixel LCD display with a blue backlight and white...
This serial LED dot-matrix module consists of an 8x8 grid of red LEDs. It is based on the...
This controller is designed to be used with a RepRap RAMPS interface board such as our RAMPS...
This 8 digit seven segment display module (HCMODU0095) uses a TM6138 controller allowing full...
A 3.2" colour TFT display module compatible with 3.3V microcontrollers such as the Arduino...
This 8x8 dot matrix LED (red) module is ideally suited for use with various microcontrollers...
These tiny 0.96 inch uOLED displays have a resolution of 128 x...
This 3.2" Colour TFT is an Arduino compatible shield that will plug directly into common types...
A larger 1.3" version of our ultra low power tiny uOLED display module. This display has the...
This 2.4" Colour TFT is an Arduino compatible shield that will plug directly into common types...
A 2.4" colour TFT display module compatible with 3.3V microcontrollers such as the Arduino...